↓ Advertise on Defender2 ↓

Home > Off Topic > Straightening warped chequer plate
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
excossack



Member Since: 22 Feb 2012
Location: North West
Posts: 5740
United Kingdom 1999 Defender 110 Td5 SW Caledonian Blue
Straightening warped chequer plate
I took the bonnet chequer plate in to get blasted and powder coated. I was advised it might warp and it has.
The metal now has a bow it in. (the edge at the top of the bonnet)

What's the best way of removing this warp? Currently clamped flat with G-Clamps but I don't think this will pull it back to shape. 1999 Defender TD5 110

Regards
John M0VAZ
Econet Station 48 no clock
Post #869104 23rd Nov 2020 11:37am
View user's profile Send private message View poster's gallery Reply with quote
ickle



Member Since: 22 Jul 2010
Location: South Vendee
Posts: 1728
France 2008 Defender 110 Puma 2.4 CSW Alpine White
Without damaging the surface, your only real option is to put small packers under the centre of the panel and gently clamp the edges past 'flat', slowly increasing the packers until it springs back flat, bit at a time until its acceptable.

good luck
Keith
Post #869113 23rd Nov 2020 1:50pm
View user's profile Send private message View poster's gallery Reply with quote
excossack



Member Since: 22 Feb 2012
Location: North West
Posts: 5740
United Kingdom 1999 Defender 110 Td5 SW Caledonian Blue
I think it might come to that. Sad 1999 Defender TD5 110

Regards
John M0VAZ
Econet Station 48 no clock
Post #869118 23rd Nov 2020 2:24pm
View user's profile Send private message View poster's gallery Reply with quote
excossack



Member Since: 22 Feb 2012
Location: North West
Posts: 5740
United Kingdom 1999 Defender 110 Td5 SW Caledonian Blue
Managed to get some warpage out of the metal. I ended up supporting two corners and bouncing up and down on the metal to bend back in to place. Clamping didn't work. There is still a section that needs warpage removing. This is towards the front edge, where the metal curves over the front of the bonnet. 1999 Defender TD5 110

Regards
John M0VAZ
Econet Station 48 no clock
Post #872398 11th Dec 2020 10:22am
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT + 1 Hour

Jump to  
<  Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
DEFENDER2.NET RSS Feed - All Forums