↓ Advertise on Defender2 ↓

Home > Technical > Jerking on Bumpy Roads
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
shoclon



Member Since: 03 Jun 2015
Location: nigeria
Posts: 2

2009 Defender 90 Puma 2.4 HT Zermatt Silver
Jerking on Bumpy Roads
My defender goes into limp mode. I have a bearmach diagnostic tool. Two faults have refused to clear. First is the “Glow plug relay circuit invalid” and the second comes up a little while after the engine is fully warmed up. It jerks on bumpy roads and gives a cylinder balance, injector leaking fault. How can I solve these problems? I have installed new parts, EGR, MAP, Glow plug Relay and a new injector on cylinder #1. Dropped the fuel tank and had it cleaned, serviced Etc. read the injector codes and learned. How can I get my defender working properly again?
Post #428333 3rd Jun 2015 2:20pm
View user's profile Send private message View poster's gallery Reply with quote
shoclon



Member Since: 03 Jun 2015
Location: nigeria
Posts: 2

2009 Defender 90 Puma 2.4 HT Zermatt Silver
In fact, when i keep the clutch depressed, it does not jerk. Whilst idling, there is also a knocking noise from beneath if the clutch is not depressed
Post #428367 3rd Jun 2015 4:54pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT + 1 Hour

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2025 Futuranet Ltd & Martin Lewis
DEFENDER2.NET RSS Feed - All Forums