↓ Advertise on Defender2 ↓

Home > Technical > Clutch bite point to high.
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
Connor1275



Member Since: 26 Aug 2021
Location: Ardross
Posts: 1

Scotland 2000 Defender 90 Td5 PU Caledonian Blue
Clutch bite point to high.
Hello,

Story is, just fitted a power spec clutch along with new Master cylinder, slave cylinder, push rod, fork and all fork bushings. Had relativey easy time back bleeding the system and the had a nice hard pedal. Driving about for a week or so i was noticing that the bite point was creeping up. Checked to make sure the master cylinder locking nuts were tight and they were, bled the system again but didn't notice any air but still have the high pedal. Popped the slave out to check if the cylinder was extending and not retracting properly due to poor master cylinder setting but the slave was free and no restrictions when returning. Played about with the pedal height via the master cylinder rod to see if i could get the bite point at a more comfortable spot but its still to high.

Does anyone have any suggestions for me as i don't seem to be getting anywhere?

I did compare components before fitting so i fitted like for like push rod as i've been caught out in the past with the longer push rods. I've also come across a part number for a shim for behind the slave cylinder but doesn't look like it was used on a Td5 Defender and it wasn't fitted to my vehicle so id think it shouldn't be required now.
Thanks for any help in advanced.
Cheers


Last edited by Connor1275 on 27th Aug 2021 1:47am. Edited 1 time in total
Post #918836 26th Aug 2021 8:29pm
View user's profile Send private message View poster's gallery Reply with quote
landy andy



Member Since: 15 Feb 2009
Location: Ware, Herts
Posts: 5408

2006 Defender 110 Td5 USW Zermatt Silver
I just adjusted mine in the pedal box.
Post #918844 26th Aug 2021 9:31pm
View user's profile Send private message View poster's gallery Reply with quote
dorsetsmith



Member Since: 30 Oct 2011
Location: South West
Posts: 4554

Post #918858 27th Aug 2021 8:14am
View user's profile Send private message View poster's gallery Reply with quote
Dinnu



Member Since: 24 Dec 2019
Location: Lija
Posts: 3141

Malta 2012 Defender 90 Puma 2.2 CSW Santorini Black
Re: Clutch bite point to high.
Connor1275 wrote:


Popped the slave out to check if the cylinder was extending and not retracting properly due to poor master cylinder setting but the slave was free and no restrictions when returning.


At first I thought is could be master cylinder adjustment, non return valve not releasing, but as the OP says that the slave is free to be pushed back freely, then it should not be that. 1988 90 Hard Top, 19J Diesel Turbo, Shire Blue - Restoration ongoing
2012 90 CSW, 2.2TDCI, Santorini Black
Post #918868 27th Aug 2021 10:22am
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
DEFENDER2.NET RSS Feed - All Forums