DEFENDER2.NET - View topic - Front lower door seals

↓ Advertise on Defender2 ↓

Home · FAQ · New Posts · My Posts · PMs · Search · Members · Map · Calendar · Profile · Donate · Register · Log In

Home > Td5 > Front lower door seals

Page 1 of 1

Print this entire topic ·

excossack

Member Since: 22 Feb 2012
Location: North West
Posts: 5745

1999 Defender 110 Td5 SW Caledonian Blue

Front lower door seals

I have a pair of the L shaped door seals such as these > http://www.ebay.co.uk/itm/LAND-ROVER-DEFEN...2083673305

How far from the door panel does the seal sit? or does the seal sit up against the door panel? 1999 Defender TD5 110

Regards
John M0VAZ
Econet Station 48 no clock

19th Sep 2015 3:44pm

roel

Member Since: 08 Aug 2009
Location: Lelystad
Posts: 2039

I just installed them too. I have 1984 doors in my td5. The parts with the holes is flush with the steel part off the doors. So the part without the holes comes from about the middle off the door to the inner side off the door and seal against the floor structure.
I am not sure if the is clear.

But It did it different. I made them on the floor-structure and sealing against the door. I am not sure if this is better or not.

Early models, the seal was on the body. Later models the seal was on the doors. I don't know where the changeover was. Somewhere between 1984 and 2003.

Roel

1984 90 2.5 na Diesel - RR V8 (1994-2001)
1997 Camel Trophy Discovery 300TDI (2001-2009)
2005 G4 Discovery III 4.4 V8 (2008-2018) It's gone but it still hurts.
2003 90 Td5 (2009-now)

19th Sep 2015 7:46pm

excossack

Member Since: 22 Feb 2012
Location: North West
Posts: 5745

I think I am with you. If you are passing by your doors with a camera - could you take a pic please? 1999 Defender TD5 110

Regards
John M0VAZ
Econet Station 48 no clock

19th Sep 2015 7:57pm

roel

Member Since: 08 Aug 2009
Location: Lelystad
Posts: 2039

I googled and found some pics.

The td5 style seals:

Click image to enlarge

Click image to enlarge

I connected my seals to the piece off metal shown on the btm off this picture:

Roel

1984 90 2.5 na Diesel - RR V8 (1994-2001)
1997 Camel Trophy Discovery 300TDI (2001-2009)
2005 G4 Discovery III 4.4 V8 (2008-2018) It's gone but it still hurts.
2003 90 Td5 (2009-now)

19th Sep 2015 8:26pm

excossack

Member Since: 22 Feb 2012
Location: North West
Posts: 5745

I should have googled as well - Thanks

That looks about 10mm from the panel side of the door? 1999 Defender TD5 110

Regards
John M0VAZ
Econet Station 48 no clock

19th Sep 2015 8:50pm

roel

Member Since: 08 Aug 2009
Location: Lelystad
Posts: 2039

I'll check tomorrow where the poprivits are in my old td5 door are located. Roel

1984 90 2.5 na Diesel - RR V8 (1994-2001)
1997 Camel Trophy Discovery 300TDI (2001-2009)
2005 G4 Discovery III 4.4 V8 (2008-2018) It's gone but it still hurts.
2003 90 Td5 (2009-now)

19th Sep 2015 9:43pm

roel

Member Since: 08 Aug 2009
Location: Lelystad
Posts: 2039

Some pics:

I measured were the pop-rivuts were on the original td5 door:

Click image to enlarge

The btm off the door is 3cm between the doorskin and the innerside and the poprivuts are about in the middle.

I put the seal here:

Click image to enlarge

Click image to enlarge

But that is not 100% nice.

Click image to enlarge

It just extends below the door.
I installed them there as I hope it will protect the door more from mud that comes up through the gap between the floor and the sidebar.

Just installed them this week and not been off-road yet so still have to see if it works. Roel

1984 90 2.5 na Diesel - RR V8 (1994-2001)
1997 Camel Trophy Discovery 300TDI (2001-2009)
2005 G4 Discovery III 4.4 V8 (2008-2018) It's gone but it still hurts.
2003 90 Td5 (2009-now)

21st Sep 2015 9:10am

Page 1 of 1

All times are GMT + 1 Hour

Jump to

< Previous Topic | Next Topic >

Posting Rules

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum