↓ Advertise on Defender2 ↓

Home > Puma (Tdci) > Inlet air temperature sensor
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
TopQ1967



Member Since: 14 Feb 2012
Location: Veghel
Posts: 226
Netherlands 2012 Defender 130 Puma 2.2 HCPU Buckingham Blue
Inlet air temperature sensor
I am getting fault code P0113 intake air temperature sensor circuit high input

And if I read the snap shot data for this fault I get an incar temperature and outside temperature of 215 deg C

When I remove the loom connector from the sensor (I presume it is the one on top of the air box) should it than normally read 0? (I get the same code and same temp value) or is this sensor situated someware else?
Live data (removed/connected) -40 deg C

Regards. Q
Post #628054 31st May 2017 9:30pm
View user's profile Send private message View poster's gallery Reply with quote
TopQ1967



Member Since: 14 Feb 2012
Location: Veghel
Posts: 226
Netherlands 2012 Defender 130 Puma 2.2 HCPU Buckingham Blue
It was a lose connector on the LH of the gearbox.
This problem solved now Smile
Post #628166 1st Jun 2017 1:00pm
View user's profile Send private message View poster's gallery Reply with quote
dorsetsmith



Member Since: 30 Oct 2011
Location: South West
Posts: 4554
Deja vu
Post #628249 1st Jun 2017 6:37pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT + 1 Hour

Jump to  
<  Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
DEFENDER2.NET RSS Feed - All Forums