DEFENDER2.NET - View topic - 1999 TD5 Defender will not start.

↓ Advertise on Defender2 ↓

Home · FAQ · New Posts · My Posts · PMs · Search · Members · Map · Calendar · Profile · Donate · Register · Log In

Home > Td5 > 1999 TD5 Defender will not start.

Page 3 of 3

Print this entire topic ·

PrettyGood

Member Since: 11 May 2018
Location: Kusel
Posts: 19

The old sensor did not have the O ring but the new one does. I tried it with and without and it didn't make a difference. I think the shim could be significant, but also the sensor itself. Could have been bad out of the box. When I put a multi meter on it and test for AC volts, I only get about .6 volts while cranking the engine. The book says its should be 2 or 3 volts. Who makes a good brand of CKP that will not cost 150 pounds?

Joseph

23rd May 2018 8:15pm

bob neville

Member Since: 30 Apr 2009
Location: Marbella
Posts: 3247

I have a Lucas one in mine but the prices seem to vary wildly.

https://www.island-4x4.co.uk/crankshaft-cr...28315.html

Bob 2015 Jaguar XE240 R Sport - goes like ....... !!
2013 Defender 90 CSW - sold
2009 Defender 110 Double Cab - sold
2001 TD5 90 CSW - offroad project - sold to a forum member
2011 Porsche Boxster - for the sunny days !

23rd May 2018 8:37pm

PrettyGood

Member Since: 11 May 2018
Location: Kusel
Posts: 19

Thanks Bob!

23rd May 2018 8:48pm

NickMc

Member Since: 01 Oct 2014
Location: Norn Iron
Posts: 1570

I’ll agree with that had a few cheap sensors and MAF junk brand new out of the box. You’d be better with a mid max on your DVOM, you won’t really see much without an oscilloscope though it’s too quick a rate to pick up a flaw really. The shim is a funny old thing brought out to cure intermittent faults still see ones that have never had it and run fine. More FPR leaks the ruin the wiring to the sensor (which is shielded cable). Try maybe an Intermotor branded one.

23rd May 2018 10:21pm

PrettyGood

Member Since: 11 May 2018
Location: Kusel
Posts: 19

I have an old fluke 77 and I don't think it is capable of min/max. I wouldn't mind picking up an O scope though. Haven't used one in 25 years but used to use them everyday when I was an electronics tech. I will look at the intermotor brand.

23rd May 2018 10:57pm

Page 3 of 3

All times are GMT + 1 Hour

Jump to

< Previous Topic | Next Topic >

Posting Rules

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum