↓ Advertise on Defender2 ↓

Home > Maintenance & Modifications > Bulkheads - repair / replace
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
kenzle8a



Member Since: 12 Feb 2020
Location: None
Posts: 1074
 
Bulkheads - repair / replace
Weighing up some options for the truck, there’s a few bits on the bulkhead that could do with some attention.

I’m looking at options but I’m less bothered by cost compared to faff, has anyone found a decent supplier of galvanised bulkheads?

Is it easy enough to replace the bulkhead without removing too much of the truck?

I’m tempted to get a galvanised one and sell the old one on.
Post #884020 8th Feb 2021 8:50pm
View user's profile Send private message View poster's gallery Reply with quote
Oldowner



Member Since: 26 Dec 2018
Location: South west
Posts: 603
United Kingdom 2007 Defender 90 Puma 2.4 HT Aintree Green
I have just seen a Paddocks one (not mine) which was delivered last week.

If you have no other option it is usuable, but it’s not that great. The construction method is different and simplified from original, understandably to make it easier to construct without dedicated pressses and spot welding machines. Also Foot wells aren’t double skinned, sloppy puddle welds on the vent hinge brackets, puddle welded bonnet hinge brackets again look a mess. Vent pressing doesn’t look “right” to me at a glance (didn’t check it with a vent in place) and they couldn’t even get the angles on the footwell to inner wing brackets right.

That said, they serve a function in that in this case it is far better than the rotten old original 200tdi one that it will be replacing, and prior to these being available there wasn’t many other options now Land Rover no longer build new replacement old spec bulkheads.
Post #884067 9th Feb 2021 6:46am
View user's profile Send private message View poster's gallery Reply with quote
kenzle8a



Member Since: 12 Feb 2020
Location: None
Posts: 1074
 
Thanks, I've been able to find nothing but mixed reviews of the replacements. Mine isn't 'that that' bad so I may opt for the decent repair. I was hoping it was more like the chassis and there were folk like XD who were making decent pattern ones.
Post #884083 9th Feb 2021 9:08am
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT + 1 Hour

Jump to  
<  Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
DEFENDER2.NET RSS Feed - All Forums