DEFENDER2.NET - View topic - Heater Blower Removal on 2.2

↓ Advertise on Defender2 ↓

Home · FAQ · New Posts · My Posts · PMs · Search · Members · Map · Calendar · Profile · Donate · Register · Log In

Home > Maintenance & Modifications > Heater Blower Removal on 2.2

Page 1 of 1

Print this entire topic ·

foggydave

Member Since: 29 Nov 2012
Location: Midlands
Posts: 263

2014 Defender 110 Puma 2.2 USW Bonatti Grey

Heater Blower Removal on 2.2

Hi
Trying to remove the Heater Blower on my MY2014 2.2
I have undone the 3 nuts I can see, one at the top and one either side but it does not budge. Are there any nuts on the back in the engine bay or inside the cab? Also do I need to take the wing off to remove the air intake duct and the washer bottle? I can loosen it both off but cannot manouvre them out without removing a lot of other stuff.

7th Nov 2019 5:03pm

skidrov

Member Since: 06 Oct 2013
Location: Melbourne
Posts: 56

2010 Defender 110 Puma 2.4 SW Fuji White

I had to swap mine out, documented here: https://www.aulro.com/afvb/showthread.php?t=268315

My car is a MY10 2.4, don't know if there's changes.

8th Nov 2019 11:33am

foggydave

Member Since: 29 Nov 2012
Location: Midlands
Posts: 263

Thanks for the link. I think there may be more on the 2.2 as it has air con and other bits. It does seem to be the inner wing that is making it tight.
One of the things I have to do is put an extra foam seal between the air intake and the blower.

8th Nov 2019 6:57pm

skidrov

Member Since: 06 Oct 2013
Location: Melbourne
Posts: 56

FWIW, mine has a/c too. Wasn't an issue in this case.

8th Nov 2019 10:12pm

michail1976

Member Since: 09 Jun 2018
Location: Krasnoyarsk
Posts: 3

2014 Defender 110 Puma 2.2 CSW Oslo Blue

Re: Heater Blower Removal on 2.2

foggydave wrote:
Hi
Trying to remove the Heater Blower on my MY2014 2.2
I have undone the 3 nuts I can see, one at the top and one either side but it does not budge. Are there any nuts on the back in the engine bay or inside the cab? Also do I need to take the wing off to remove the air intake duct and the washer bottle? I can loosen it both off but cannot manouvre them out without removing a lot of other stuff.

The fan seal is glued to the motor Board, it must be carefully torn off.

9th Nov 2019 7:31am

Page 1 of 1

All times are GMT + 1 Hour

Jump to

< Previous Topic | Next Topic >

Posting Rules

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum