Ronin wrote:

The time has come for me to sell my Flatdog DRL bumper.

This is made by Mantec for Flatdog from 5mm steel. I have installed a FirstFour heavy duty recovery shackle in the bumper so as to provide a proper recovery point at the front of the Defender (which was never needed!).

I have a spare, matching DRL should one be required, as well as a spare DRL controller, and both will be included in the sale.

The bumper will also include the one-off DRL shields which I made to protect the rear of each DRL from road spray from the front tyres, as well as the loom which I made up to connect the lights direct to the battery and to the side-light shield.

The bumper is in excellent condition, though there are the beginnings of a few tiny rust bubbles around the holes on the underside of the bumper which accommodate the DRL mounting brackets. There is also a small mark on the front side of the bumper caused when my holesaw broke

Ideally, the bumper will be collected from Tunbridge Wells, though I will pack it for the buyer's courier if necessary.

I'm after £160 with the Land Rover end caps or £145 without. These are out of stock at Flatdog but retail for £210 (without the recovery point, end caps, spare DRL and controller, loom or DRL shields).

Any questions, please shout.

Cheers,

Joel


Click image to enlarge


Click image to enlarge


Click image to enlarge


Click image to enlarge

There are some great photos of the bumper on this thread: http://www.defender2.net/forum/topic22257.html?highlight=fcx+drl (thank you Matt of FCX).

Has Davina McCall touched this bumper? Must be worth more, surely? :thumbsup:

Admin note: this post has had its images recovered from a money grabbing photo hosting site and reinstated  Monsieur Le Grenadier

I've not been everywhere, but it's on my list.....

2011 Puma 110DC - Corris Grey