Author |
Message |
Black smoke at low revs 2.4 TDCI |
Moffett
24th Aug 2021 9:53pm
|
Forum: Puma (Tdci) · Replies: 27 · Views: 12050 · Subject: Black smoke at low revs 2.4 TDCI |
Nope, the inner isn't cut so it was still holding some pressure. The turbo must work hardest pulling from 2-3k revs as the smoke would clear up before and after. If I drove fast it never happened. Whe ... |
Black smoke at low revs 2.4 TDCI |
Moffett
24th Aug 2021 2:42pm
|
Forum: Puma (Tdci) · Replies: 27 · Views: 12050 · Subject: Black smoke at low revs 2.4 TDCI |
I know you have both checked already, but I missed a fairly big split in mine. The symptoms you both have are so similar to mine in rev range etc. It could well be a boost leak somewhere or other? |
Black smoke at low revs 2.4 TDCI |
Moffett
22nd Aug 2021 4:42pm
|
Forum: Puma (Tdci) · Replies: 27 · Views: 12050 · Subject: Black smoke at low revs 2.4 TDCI |
These symptoms are very similar to mine, did ye check both hoses and intercooler? |
Engine stutter on start up |
Moffett
4th Aug 2021 4:47pm
|
Forum: Puma (Tdci) · Replies: 1 · Views: 1141 · Subject: Engine stutter on start up |
Temperature gauge jumps up momentarily also... but it always starts, for now! |
Help please with fault codes and diagnosis. |
Moffett
4th Aug 2021 1:56pm
|
Forum: Puma (Tdci) · Replies: 8 · Views: 3252 · Subject: Help please with fault codes and diagnosis. |
I remember reading the actuator should feel quite loose? Not taken mine off..... yet.. |
Engine stutter on start up |
Moffett
4th Aug 2021 1:49pm
|
Forum: Puma (Tdci) · Replies: 1 · Views: 1141 · Subject: Engine stutter on start up |
Hi folks, truck is starting up, but then stutters and even though it doesn't knock off, it resets the timer for the glow plugs whick illuminates on the dash again even though the engine is running. An ... |
Black smoke at low revs 2.4 TDCI |
Moffett
2nd Aug 2021 9:46pm
|
Forum: Puma (Tdci) · Replies: 27 · Views: 12050 · Subject: Black smoke at low revs 2.4 TDCI |
https://www.defender2.net/gallery/albums/userpics/23143/normal_DSC_0554.JPG
Massive split, I am surprised the truck ran as well as it did! The inner is not spilt so it is holding some pressure I supp ... |
Black smoke at low revs 2.4 TDCI |
Moffett
2nd Aug 2021 5:20pm
|
Forum: Puma (Tdci) · Replies: 27 · Views: 12050 · Subject: Black smoke at low revs 2.4 TDCI |
Cured mine also, split intercooler pipe.... and I had checked them, but not well enough! |
Black smoke at low revs 2.4 TDCI |
Moffett
17th Jul 2021 10:04pm
|
Forum: Puma (Tdci) · Replies: 27 · Views: 12050 · Subject: Black smoke at low revs 2.4 TDCI |
I have this, mostly in 5th or 6th at about 2500rpm. I have cleaned map and maf, done the injectors and serviced it. No difference. I have an intercooler and silicone pipes to fit next. The truck has g ... |
Changing the radiator |
Moffett
1st Jul 2021 6:59pm
|
Forum: Puma (Tdci) · Replies: 20 · Views: 3235 · Subject: Changing the radiator |
I was worried about that, did you recharge the aircon yourself? Pictures would be greatly appreciated! |
Intermittent starting problem - 2010 2.4 Puma |
Moffett
30th Jun 2021 9:37pm
|
Forum: Puma (Tdci) · Replies: 9 · Views: 3891 · Subject: Intermittent starting problem - 2010 2.4 Puma |
Hi Dorsetsmith, where do you get a hold of the service bulletins? |
Changing the radiator |
Moffett
30th Jun 2021 9:33pm
|
Forum: Puma (Tdci) · Replies: 20 · Views: 3235 · Subject: Changing the radiator |
Hi folks, I have a new rad and intercooler. Is this a massive job? Will I be able to work around the aircon condenser? And have new intercooler pipes too. Any advice would be appreciated. |
More VCV Questions |
Moffett
30th Jun 2021 9:24pm
|
Forum: Puma (Tdci) · Replies: 14 · Views: 5260 · Subject: More VCV Questions |
The vcv had cured the limp home issue, but not the black smoke. I could change the vcv now in under ten minutes, but I would be weary of air locking the system again! If she is a bit lump on start up, ... |
More VCV Questions |
Moffett
25th Jun 2021 6:52pm
|
Forum: Puma (Tdci) · Replies: 14 · Views: 5260 · Subject: More VCV Questions |
Well, after a monumental amount of bleeding to no avail the truck turned over and idled nicely after one squirt of easy start......... A result I suppose. I have been driving it for the last hour with ... |
More VCV Questions |
Moffett
20th Jun 2021 9:32pm
|
Forum: Puma (Tdci) · Replies: 14 · Views: 5260 · Subject: More VCV Questions |
Well okay, I have cranked the truck with Nanocom on and fuel pressure does not pass. 25mpa or 36psi.....looks like I have drained the fuel rail now. If the pump is primed will it bleed without the inj ... |
|