↓ Advertise on Defender2 ↓

Home > General & Technical (L663) > Discreet door edge protection
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
Co1



Member Since: 19 Aug 2018
Location: North Yorkshire
Posts: 3626
United Kingdom 2013 Defender 90 Puma 2.2 HT Loire Blue
Discreet door edge protection
My driveway is pretty tight, and I can’t open my drivers door the full way and now and again I have been known to “kiss” the wall. So far very little paint damage, but it’s inevitably going to happen. Any thoughts on discreet edge protection? Not the big black rubber things on ‘80s hot hatches, something a bit less obvious.

Any thoughts?

Col
Post #1002587 1st Aug 2023 8:16pm
View user's profile Send private message View poster's gallery Reply with quote
MickD



Member Since: 28 Jul 2023
Location: New England
Posts: 28
United States 
Have you considered putting a bumper on the wall instead?


Post #1002600 1st Aug 2023 8:44pm
View user's profile Send private message View poster's gallery Reply with quote
zilch



Member Since: 11 Sep 2019
Location: Whitsundays & Sydney
Posts: 788
Australia 
as per MickD suggestion..

at our previous home in the UK the garage was very slim, we put 1 inch thick foam on plywood
boards and screwed them to the wall where the doors open up.. stopped the door getting dinked yet another pommie bar steward down under

MY20 110 P400 SE Defender
MY10 3.0 RR Sport
Post #1002628 2nd Aug 2023 2:52am
View user's profile Send private message View poster's gallery Reply with quote
Co1



Member Since: 19 Aug 2018
Location: North Yorkshire
Posts: 3626
United Kingdom 2013 Defender 90 Puma 2.2 HT Loire Blue
MickD wrote:
Have you considered putting a bumper on the wall instead?




I have. The question would be discreet wall bumpers!! I would prefer this though so that I can leave the car unmolested. Was thinking about a strip of Perspex?
Post #1002637 2nd Aug 2023 6:02am
View user's profile Send private message View poster's gallery Reply with quote
Norfolk-n-chance



Member Since: 02 Sep 2019
Location: Usually in the garage!
Posts: 80
United Kingdom 2015 Defender 110 Puma 2.2 XS CSW Santorini Black
Better to be something non transparent, after a while it’ll just turn green under the Perspex….

Presumably you always park in roughly the same spot? How about a strip of timber horizontally at the right height? “a committee is a group of people who individually can do nothing, but as a group decide nothing can be done.”
Post #1002644 2nd Aug 2023 7:57am
View user's profile Send private message View poster's gallery Reply with quote
Zed



Member Since: 07 Oct 2017
Location: In the woods
Posts: 3088
United Kingdom 2010 Defender 110 Puma 2.4 XS CSW Santorini Black
I attached a strip of foam I had lying about using self adhesive Velcro but you can buy specific garage wall protectors from Amazon etc for £10-20. WARNING.
This post may contain sarcasm.
Post #1002733 2nd Aug 2023 3:15pm
View user's profile Send private message View poster's gallery Reply with quote
Moo



Member Since: 01 Oct 2021
Location: Bath
Posts: 1106
Ukraine 
I've got some very thin and discrete door protection strips I used on my Spider. I'll see if I can find out where I got them from. Eiger Grey MY23 D250 SE with bits. Known as Noddy.
Post #1002734 2nd Aug 2023 3:34pm
View user's profile Send private message View poster's gallery Reply with quote
Dinnu



Member Since: 24 Dec 2019
Location: Lija
Posts: 3233
Malta 2012 Defender 90 Puma 2.2 CSW Santorini Black
How about some clear edging, similar to below. Cheap enough to replace when it gets dull.

https://m.nl.aliexpress.com/item/100500402...910228fca5 1988 90 Hard Top, 19J Diesel Turbo, Shire Blue - Restoration ongoing
2012 90 CSW, 2.2TDCI, Santorini Black
Post #1002743 2nd Aug 2023 4:59pm
View user's profile Send private message View poster's gallery Reply with quote
Co1



Member Since: 19 Aug 2018
Location: North Yorkshire
Posts: 3626
United Kingdom 2013 Defender 90 Puma 2.2 HT Loire Blue
Moo wrote:
I've got some very thin and discrete door protection strips I used on my Spider. I'll see if I can find out where I got them from.


That would great thanks.
Post #1002747 2nd Aug 2023 5:36pm
View user's profile Send private message View poster's gallery Reply with quote
Co1



Member Since: 19 Aug 2018
Location: North Yorkshire
Posts: 3626
United Kingdom 2013 Defender 90 Puma 2.2 HT Loire Blue
Norfolk-n-chance wrote:
Better to be something non transparent, after a while it’ll just turn green under the Perspex….

Presumably you always park in roughly the same spot? How about a strip of timber horizontally at the right height?


Yep, always the same place. I did think that if I can’t make it discreet then a nice strip of oiled oak would be second best.
Post #1002748 2nd Aug 2023 5:37pm
View user's profile Send private message View poster's gallery Reply with quote
Co1



Member Since: 19 Aug 2018
Location: North Yorkshire
Posts: 3626
United Kingdom 2013 Defender 90 Puma 2.2 HT Loire Blue
Dinnu wrote:
How about some clear edging, similar to below. Cheap enough to replace when it gets dull.

https://m.nl.aliexpress.com/item/100500402...910228fca5


Cheers Dinnu, that looks like a viable option.
Post #1002749 2nd Aug 2023 5:37pm
View user's profile Send private message View poster's gallery Reply with quote
Moo



Member Since: 01 Oct 2021
Location: Bath
Posts: 1106
Ukraine 
I used the black version of that. - My Spider was black. Worked really well.

This is it:

https://www.ebay.co.uk/itm/175840096557?ha...BM3Mfu6rZi Eiger Grey MY23 D250 SE with bits. Known as Noddy.
Post #1002753 2nd Aug 2023 6:01pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT + 1 Hour

Jump to  
<  Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
DEFENDER2.NET RSS Feed - All Forums