↓ Advertise on Defender2 ↓

Home > In Car Electronics > Can anyone help with switch wiring (heated seats)
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
Welkman



Member Since: 02 Nov 2014
Location: Essex colchester
Posts: 326

United Kingdom 
Can anyone help with switch wiring (heated seats)
Hi guys,

I have fitted an exmoor trim heated seat unit which consists of a relay with four wires coming from it going to a three way switch (circuit on for low, circuit on for high, off). The switch at the moment lights up green all the time and gives 12v to the heater elements only when switched to low, it should only light green on low, be off when the seats are off and red when switched to high power. Under high power no power goes to the seats.

I did cut and extend the loom as it was too short but have checked continuity of my extensions and am 100% that they are correct.


I have not tried moving the connections on the switch yet as I am fairly certain that it would not have come from the factory incorrectly connected?

Any ideas on what to check?

Cheers James
Post #640409 28th Jul 2017 7:54pm
View user's profile Send private message View poster's gallery Reply with quote
pepethekingprawn



Member Since: 12 Jan 2016
Location: Lancashire
Posts: 54

United Kingdom 1989 Defender 90 V8 Petrol ST Auto Chawton White
Where are you getting 12v supply from? Did the kit come with a wiring diagram?
Post #640911 31st Jul 2017 1:44pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
DEFENDER2.NET RSS Feed - All Forums