 | Home > My Defender > Alan |
 
|
|
|
| grafty99 Member Since: 15 Aug 2012 Location: North Devon Posts: 4784   
|
Haha, I'm not sure being towed at that speed would be a good idea
 2002 90 Td5 Station Wagon
1990 Vogue SE Triumph Tiger Explorer 1200 Td5 90 Thread http://www.defender2.net/forum/topic50767.html Tdi 110 Thread https://www.defender2.net/forum/topic69562.html RRC Thread http://www.defender2.net/forum/topic54492.html Instagram http://www.instagram.com/george_grafton |
||
6th Jul 2017 10:40pm |
|
| grafty99 Member Since: 15 Aug 2012 Location: North Devon Posts: 4784
|
Good stuff
 where did you mount the switch? 2002 90 Td5 Station Wagon
1990 Vogue SE Triumph Tiger Explorer 1200 Td5 90 Thread http://www.defender2.net/forum/topic50767.html Tdi 110 Thread https://www.defender2.net/forum/topic69562.html RRC Thread http://www.defender2.net/forum/topic54492.html Instagram http://www.instagram.com/george_grafton |
||
|
7th Jul 2017 3:41pm |
|
| Procta Member Since: 04 Dec 2016 Location: Sunderland Posts: 4932
|
get some photos up! This could be my next move at some point. Defender TD5 90 ---/--- Peugeot 306 HDI hatch back
Success is 90% Inspiration and 4 minutes Preparation # you can make it! |
||
|
7th Jul 2017 4:02pm |
|
| Profyaffle Member Since: 03 Oct 2016 Location: N Yorks Posts: 526
|
There isn't much to photo and I had to go to work after
The switch replaced the one blank one on the binnacle, right side bottom edge.. I routed it as Grafty said.. out of the battery box, along the chassis leg and up the bulkhead.. across to the drivers side and in through the grommet at the back of the binnacle... I managed to not take the dash top off and fed the positive up the side behind the heater controls.. the earth on the other side I have fixed to the bolt holding the door stay to the bulkhead... I haven't made any connections yet and I need to find an ignition live somewhere round the dash... I have booked the screen to come on Thursday, this I bought off Ebay £180 inc fitting at home 1993 200Tdi Defender 90 |
||
|
8th Jul 2017 2:00am |
|
| Procta Member Since: 04 Dec 2016 Location: Sunderland Posts: 4932
|
my dad tapped into the ignition barrel its self when we wired in the spot lamps. Defender TD5 90 ---/--- Peugeot 306 HDI hatch back
Success is 90% Inspiration and 4 minutes Preparation # you can make it! |
||
|
8th Jul 2017 2:05pm |
|
| Profyaffle Member Since: 03 Oct 2016 Location: N Yorks Posts: 526
|
Cheers Procta.. I will have a poke about..
here is the switch.. Only snag is the instructions say two green to outside pins and yellow to the middle.. whereas the colours are reversed on mine.. I have emailed MC to clarify..  Click image to enlarge 1993 200Tdi Defender 90 |
||
|
9th Jul 2017 10:39am |
|
| grafty99 Member Since: 15 Aug 2012 Location: North Devon Posts: 4784
|
Looks neat there
2002 90 Td5 Station Wagon
1990 Vogue SE Triumph Tiger Explorer 1200 Td5 90 Thread http://www.defender2.net/forum/topic50767.html Tdi 110 Thread https://www.defender2.net/forum/topic69562.html RRC Thread http://www.defender2.net/forum/topic54492.html Instagram http://www.instagram.com/george_grafton |
||
|
9th Jul 2017 11:37am |
|
| Profyaffle Member Since: 03 Oct 2016 Location: N Yorks Posts: 526
|
Thanks... I think I have dislodged the speedo cable the needle is wondering about a bit.. Il didn't unplug it but I did pull it about a bit getting my little paws in to pull the wires through...
 1993 200Tdi Defender 90 |
||
|
9th Jul 2017 11:44am |
|
| grafty99 Member Since: 15 Aug 2012 Location: North Devon Posts: 4784
|
Yeah it may just be caught up on somthing. Too sharp a bend can slow it down and cause needle wobble
2002 90 Td5 Station Wagon
1990 Vogue SE Triumph Tiger Explorer 1200 Td5 90 Thread http://www.defender2.net/forum/topic50767.html Tdi 110 Thread https://www.defender2.net/forum/topic69562.html RRC Thread http://www.defender2.net/forum/topic54492.html Instagram http://www.instagram.com/george_grafton |
||
|
9th Jul 2017 12:02pm |
|
| L110CDL Member Since: 31 Oct 2015 Location: Devon Posts: 10478 
|
Great progress on the wire loom Profyaffle and a neat switch, looks as if its always been there
 1996 Golf Blue 300Tdi 110 Pick up. Keeper.
Clayton. |
||
|
9th Jul 2017 10:09pm |
|
| Profyaffle Member Since: 03 Oct 2016 Location: N Yorks Posts: 526
|
whilst I was making the ignition live connection to the heated windscreen loom I added a couple of extra bits..
LED lighting in the footwell and a voltmeter, both controlled by a switch.. I used existing spare feeds in the dash with the old style bullet connectors.
1993 200Tdi Defender 90 |
||
|
11th Jul 2017 1:11pm |
|
| grafty99 Member Since: 15 Aug 2012 Location: North Devon Posts: 4784
|
Nice!
2002 90 Td5 Station Wagon
1990 Vogue SE Triumph Tiger Explorer 1200 Td5 90 Thread http://www.defender2.net/forum/topic50767.html Tdi 110 Thread https://www.defender2.net/forum/topic69562.html RRC Thread http://www.defender2.net/forum/topic54492.html Instagram http://www.instagram.com/george_grafton |
||
|
11th Jul 2017 4:41pm |
|
| Procta Member Since: 04 Dec 2016 Location: Sunderland Posts: 4932
|
neat little upgrades there
Defender TD5 90 ---/--- Peugeot 306 HDI hatch back
Success is 90% Inspiration and 4 minutes Preparation # you can make it! |
||
|
11th Jul 2017 5:22pm |
|
| Silver Back Member Since: 11 Jun 2015 Location: Lincolnshire Posts: 405 
|
Every time I see this thread I can't help thinking of ...
https://www.youtube.com/watch?v=F0BfcdPKw8E  |
||
|
11th Jul 2017 10:52pm |
|
|
|
| All times are GMT + 1 Hour |
< Previous Topic | Next Topic > |
Posting Rules
|
Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
